I’m the first to admit that hand-made tissue box covers can go horribly, horribly, wrong. But stick with me – they don’t have to. In fact, they can add a little charm to just about any room.
If you are looking for an easy to make gift, or simply to brighten up one of your own spaces, you might want to give these covers a try.
Using the tutorial as a guide, I made a pattern for the cube shaped style of tissue box. You could make your cover as simple as a single layer of opaque fabric. Or you could make something padded, lined, and trimmed. It’s really up to you.
I opted for a more finished cover with bias trim and a lined inside. So for each cover, I used the pattern to cut 5 layers:
- Outer fabric
- Lining fabric
- 2 Interfacing (I used a medium weight fusible)
- Batting (I used a fusible version)
Fuse the interfacing to the wrong side of the fabric pieces. Trim the batting piece to remove the seam allowance (or just cut smaller to begin with). Then fuse it to the interfacing side of the outer fabric.
Through all layers, stitch an outline of the top edge of the box shape. Then clip the corners to the stitching line.
Cut a hole in the center slightly smaller than the desired opening. Cut into the hole’s corners to make tabs that can be folded to the inside. Clip or pin the tabs to the inside then carefully topstitch them in place.
To trim the opening, you can simply place binding tape or trim on the inside of the box and sew in place. Or you can be fancy and apply the binding around the hole’s edge.
To get a perfect fit, pin the side seams while arranging the cover lining-side out over a tissue box. Then make a strong overcast seam on all four sides.
To finish, apply contrasting trim around the bottom edge.
TIP: Keep a covered empty tissue box at your sewing station. It’s a great place to tuck thread clippings and other small trash as you work.
- Fabric: inner, outer: any woven fabric will do. I like quilting cottons just for the variety of designs available. Requirements will vary depending on the size of the tissue box. You will need a piece slightly larger than 2 x height of box side + (box length) X 2 x height of box side + (box width). Great for those scraps you can’t get rid of!
- Bias Tape: buy the pre-packaged kind or make your own. In this case, you don’t have to cut bias strips. You can cut your strips on the grain because it won’t need to stretch around curves. So, you can use those little scraps for this too!
- Fusible interfacing: The stiffer the interfacing, the crisper looking your cover will be. I used Pellon SF101, but you can go softer or harder if you prefer.
- Batting: I happened to have some fusible fleece on hand, but any batting will do.
More coming soon!